This video will show a carpet transition turn n tack method the correct way to get great results while roll and staple carpet.
Tack strip between carpet and wood floor.
Fasten the pad to the wood subfloor with staples every 10 12 in each direction.
Locate the brad nails that hold the first piece of tack strip to the floor.
Concrete tack strip uses hardened steel nails that can penetrate concrete.
Connect a gap in your flooring or cover connect a gap in your flooring or cover up a seam with the exclusive silver fluted carpet trim from trafficmaster.
If padding over a concrete floor use adhesive.
Designed to eliminate your carpet edges from fraying vinyl floor edging from curling.
Step 3 place the curved edge of a small pry bar against the tack strip lining the pry bar up with the first nail.
Staple the pad against the edge of the tack strip.
This will allow an approximate 1 4 inch gap between.
Make quick work of creating a smooth transition between two different flooring surfaces with help from trafficmaster.
I love using the wonder tool and these pliers for this job.
It will also show what not to.
Run a carpet knife against the strip to trim the pad.
Once you have all of the tack strips up it is time to remove any staples on the floor from the carpet pad.
Typically there will be three nails spaced evenly along each three foot section of tack strip.
Work toward the tack strips smoothing the pad and stapling.
For thinner carpet you may want to place it closer and vice versa for thicker carpeting.
Cut a strip of carpet reducer to the length you measured using a chop saw.
A lot of times i can just use the pliers to get the staples up but some staples are so close to the floor that i need to use the wonder tool to get them started.
When installing the strip fold back the carpet and pad so it s out of the way and place the strip approximately 1 2 away from the finished wood floor.