So on a table saw the right side should be facing up and when using a handheld circular saw it should be facing down.
Table saw finish side up.
That way any splintering occurs out of sight on the side that faces.
The finished side of your wood must be at the bottom.
As with any saw cut keep in mind which side of the line you wish to cut.
If for example you run out of 80 grit sanding discs halfway through the initial sanding you might be tempted to switch to 100 grit.
Because a circular saw blade cuts on an upward rotation the bottom face in which the teeth enter the cut will almost always have a clean tear out free surface.
Depending on which saw you own however locations of parts on the saw and results may vary.
Face up on a table saw face.
When you use a mitre saw make sure the finished side of the wood is facing forward.
That s why a table saw is handled opposite a circular skil saw.
But you could use a table saw for the crosscutting as well with help of another person.
Since saw blades tend to splinter material as they exit the wood run laminate flooring planks with the good side facing up.
Jeff you want to cut it good side down with a skill saw in my book unless you have a zero insert type skill saw like the festool the ripping on the table saw would be good side up.
To get the cleanest cut possible remember these tips.
Any variation in sanding steps can show up in the final finish.
For table and miter saws invest in an 80 tpi plywood blade one designed for cross miter saw or rip table saw cuts.
Then add a strip of masking tape to both the top and bottom of the sheet directly over the cut line.
Do the exact opposite when you are using your power saw.
To help you remember in the future you want the teeth to enter the wood on the good side exit on the less good side.
Then when making your cuts set yourself up for success.
This is one thing to keep in mind as these are simply basic table saw assembly instructions that are for the most typical of saws on the market.
No matter what reason it is we are here to assist you with how to set up a table saw from start to finish.
You want the teeth pulling the fibers into the wood for best cut side not pulling the out.
Sand every square inch the same.
Whenever you run wood through a table saw always make sure that your finished side is up.
Meanwhile the top face suffers tear out so bad it cannot be used in a visible area on a project.